Fixing the blocks
I present the fixing of the blocks on this side.
My motherboard (AOpen AK79D-400VN) the socket of a processor (462 pins, Socket A) circle four holes can be found, which ones the processor refrigerator holding down meant to serve. The bores 36,14 or 66,09 milimetre find a job from each other. If we join the opposite bores in imagination with a line, then these two straights prunes each other above the centre of the processor seed. I fixed the water system with the help of these holes.
I prepared this holding down element from a four milimetre thickness aluminium slip:
Concerning the sideway shift of the block turning two calibrating a screw hinders it. These screws - which ones cling into the roof of the block - the holding down into a disk from above they are winding.
The fixing of the GPU block a task was more complex with a small one already. I have to fix the block to the Sapphire Ati Radeon 9600XT VIVO card steadily. The difficulty the card his deficiency caused it on the one according to which only two are tiny - altogether three milimetre diameter - there is a bore go ahead. They hanged on at these holes originally the card - factory - his air cooling plastic fixing his elements.
It brought about an additional problem that the card is the lower stump of the block just one holding down his bore fell above it. It made the implementation a little bit more complicate. But I solved it...
In the interest of the stronger fixing the vga on the back side of a card the part between the two bores a yellow brass I overcame it with a sheet. This in the middle - behind the chip - a rubber I supported it with scrap. I created a hurrying effect that GPU is through the centre of a chip hereby was concentrated.
______________________________________
17.07.2007
I bought a new computer in the first week of 2007 Julies. To the water cooling new holding down I had to prepare elements. It - MSI K9N4-Ultra - motherboard AM2 case, four take action likewise around a processor settling down with a hole.
On the VGA card (ASUS EAX1300PRO) I may have used four holes for the fixing of the water system likewise this time.
|
- 7 - |
