Chipset block

I made two types of chpset cooling blocks. I used also the AutoCAD program. The firs one:

	Chipset_block-1 parameters
	Material of block body:	red copper
	Material of the cap and stubs:	yellow brass
	Size of block body:	40x40x16 (mm)
	Size of block cap:	40x40x2 (mm)
	Size of block:	40x40x18 (mm)
	Depth of sole:	7,6 mm
	Latitude of route:	3 mm
	Inside cross section of route:	50,3 mm2
	Latitude of wall:	3 mm
	Active heat transfer area:	40 cm2

---

I thought that this block would be an a little bit serious one for one cooling chips later. I would not have been able to fix it onto my motherboard rather certainly, moreover unnecessary here refrigeration performance of this size. I planned smaller one instead because of this.

	Chipset_block-2 parameters
	Material of block body:	red copper
	Material of the cap and stubs:	yellow brass
	Size of block body:	40x40x5 (mm)
	Size of block cap:	40x40x2 (mm)
	Size of block:	40x40x7 (mm)
	Depth of sole:	2,2 mm
	Latitude of route:	2,8 mm
	Inside cross section of route:	50 mm2
	Latitude of wall:	1 mm
	Active heat transfer area:	13,5 cm2

I made two from this one:

Was of two kinds so finally chips my refrigerator block. I do not use one however currently. Fenthagytam my motherboard the original factory cooling flange. There is not a trouble with him, is not getting warm extremely.

<<

- 6 -

>>